Templates  

Kits   

Project Pages

Mizuhiki

Other Stuff

What's new/ Specials

A Studley Box

-"Box" template from Draggin' Ink J
-Two pieces heavy cardstock (10 pt or higher)
-9-15 brass fasteners
-Scissors
-pencil
-ruler
Optional if fusing paper:
-1 sheet crushed tissue paper, solid color
-plastic wrap
-iron

If using a piece of fused paper for the top, fuse the paper before marking. Make box top and lid according to directions. Unfold the top and on the inside mark a pattern that you would like to have showing on the outside. With the end of the scissors or the pencil tip, poke a small hole through to the other side, just enough to be a starter hole for the legs of the brass fasteners. Turn piece over and insert the brass fasteners in the pattern of your choice. Flatten the legs out on the underside. If desired, tape down the legs to keep them as flat as possible.

Cool technique! For an extra bit of color, try this...heat up the head of the brass fastener with a heat gun, dip in colored embossing powder and heat again. Wow!   Make sure you clip the brass fastener into the Original Draggin' Ink Sponging Tool, a clothespin or some other tool to prevent burnt fingers.

Look for Draggin' Ink J supplies and accessories at your local stamp &craft store.
82000 Draggin= Ink J All rights reserved. No part of this may be reproduced except for personal use.

                                         Find this template

                      Table of Contents